Installing heat sink on ALIX.3D3

A few days ago, while I was compiling some stuff on my ALIX.3D3, I discovered a very high CPU temperature by chance:

M/B Temp:    +59 C  (low  =    +0 C, high =   +70 C)
CPU Temp:  +71.1 C  (low  =  +0.0 C, high = +70.0 C)   ALARM
Alix.3D3 with heat sink

Alix.3D3 with heat sink

I downloaded the datasheet of the AMD Geode LX800 CPU to check which temperatures are OK. On page 598 I found that my model (ALXD800EEXJ2VD) is fine for temperatures from 0 °C to 85 °C. Anyway I looked in my spare part box if I could find a suitable heat sink and fortunately I found a 40mm x 40mm x 9mm one. So I ordered some thermal adhesive and installed it.

To see the advantage of it, I did some measurements. I compiled cpuburn and let it ran with and without heat sink. I tried with and without the case. All measurements were made with a Intel 2915AGB WiFi card and a SanDisk 4 GB Extreme III Compact Flash card installed. Room temperature was between 23.8 °C and 24.5 °C.

ALIX.3D3 CPU temperatureAfter some start time it's possible to see that temperature differences between the with heat sink and without heat sink curves is about 4 °C. After running the board for about an hour with 100% CPU load with the case, temperature was about 66.6 °C. That's about 4 °C less than the measured 71.1 °C in the screenshot above.

So installing the heat sink results in only about 4 °C temperature difference, but installation was very simple and cheap.

This entry was posted in Alix and tagged , by twam. Bookmark the permalink.

About the author

My name is Tobias Müller. I'm interested in com­puters, physics, elec­tronics and photo­graphy. more …

3 thoughts on “Installing heat sink on ALIX.3D3

  1. As the temperature curve did not converge against a constant value this data does not say anything.
    The time of the data series are too short...

  2. I have an NorhTec MicroClient Jr computer. It has a rather heavy aluminum extruded case with heat-sink-like ripples on the outside. Inside, there is a funny rubber block with adhesive that ensures a thermal contact between the CPU surface and the inside of the case.

    If you could figure out a heat sink which would have a reliable thermal contact with your case, I bet you would have a substantial decrease in your measured CPU temperature.

    Thanks for your notes on the Alix boards.

Leave a Reply to Manuel Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.